Power supply voltage AC100 ~ 240V (wide range)
Output capacity: DC5V 4.6A, with a replacement time notification.Unit type: CJ1 CPU Bus Units.
Product Name: Position Control,
Unit with MECHATROLINK-II interface.
Specifications: Control commands,
executed by MECHATROLINK-II,
synchronous communications CS1W-CLK23 I/O Wiring Diagram.
Direct operation by ladder programming.
Control mode: Position control,
speed control or torque control;
No CS1W-CLK23 of axes: 2 axes.
No. of unit numbers allocated: 1.
Current consumption : 5V, 0.36A; 24V,--.
Standards: UC1, CE.
Decrease TCO with Simple Operation,
Reduced Wiring, Batch Settings,
and Batch Management.
Control Servos for up to 16 axes in,
a motion network with one Position,
Control Unit that supports MECHATROLINK-II CS1W-CLK23 I/O Wiring Diagram.
MECHATROLINK-II is a registered trademark,
of the MECHATROLINK Members Association. C500-OC I/O Unit Transistor Output 16 pts C500-OC223(3G2A5-OC223).
AC250/DC24V 2A.C200HS-CPU33-E CPU
High-Performance CIM Version, Built-in RS-232C Port
The C200HS-CPU31-E and C200HS-CPU33-E controller offers the same basic functionality as the C200HS-CPU01-E/CPU03 controllers CS1W-CLK23 I/O Wiring Diagram.
This CPU may be used ineither SYSMAC NET and/or SYSMAC LINK communication systems.
The built-in RS-232C port supports the same communications as the C200HS-CPU21/CPU23.Model: C1000H-TER01.
Each node requires one of the ends of the network.C500-AS Special I/O Unit ASCII BASIC UNIT C500-ASC01.Number of inputs: 8 pts.
Input Voltage: 200 to 240VAC.
Input Current: 6 mA.Name: Screw Terminal Block with SSR Outputs.
Specifications: Outputs;
8 outputs; SSR.
"Easy" and "Flexible" system expansion,
with linked CC-Link and CompoNet.
Branching is easily made with CompoNet.
Wiring material cost ccan be reduced CS1W-CLK23 Manual.
Bit-level I/O distribution reduces,
wiring in the system.
A wide variety of CompoNet Slave Units,
contribute to system size reduction.
Seven-segment Display on the Gateway Unit,
helps to detect errors on sitee CS1W-CLK23 Manual.
The Participation Flags and Communications,
Error Flags can be checked at the Host,
Controller to detect the location and,
content of the error.