Fitting materials: Stainless steel (SUS304).
Count: 1.
Accessories: Description, Slotted/Phillips screws M3,
(with spring and plain washers);
Material, Stainless steel (SUS304); Count, 2 .
Applicable sensor (mounting pitch on sensor side): E3Z pre-wired model.
Page: Dimensions, 7.
High performance price ratio standard type proximity sensor EE-SX676-C1J-R INSTRUCTION sheet.
Standard cable protector EE-SX676-C1J-R
The new DC two-wire type.
Non polar proximity sensor.
Type: DC two-wire / connector type.
Polarity: there.
Shape: shield, M30.
Detection range: 10mm.
Action mode: NO. Size: 96 x 96mm.
Type: power AC/DC24V with.
Shell color: black.
Control output 1: position ratio with relay output.
Control output 2: position ratio with relay output EE-SX676-C1J-R INSTRUCTION sheet.
Control mode: standard or heating cooling.
Auxiliary output points: 2 points.
Heater break, SSR fault detection function: single phase or three phase heater detection function.
Event entry point: 2.
Transfer output: -.
Remote SP:4 to 20mA input.
Communication: RS-485.
New program type.
A new type of liquid crystal with high performance cost ratio is adopted in the 256 paragraph,
Visual angle, contrast can be improved EE-SX676-C1J-R INSTRUCTION sheet.
Can be set up to 8 procedures (mode) x 32 (step) procedure.
High resolution 5 bit display / can display 0.01 degrees C.
High speed sampling period 60ms.
All models complete a variety of (to the thermocouple /Pt/ analog input switching), 1 machines to support a variety of sensors.
Also supports remote SP.
Add PV/SV state display function, to see the state of the thermostat
(automatic / manual, RUN/RESET, alarm), interactive display PV/SV.
Through the support software (Ver.4.3 CX-Thermo) makees the process of setting management becomes very
Simple use of simple computing functions (AND/OR logic and delay) to set the implementation of flexible contact output EE-SX676-C1J-R Manual.
Through the infrared port can be carried out from the frront of the communication EE-SX676-C1J-R Manual.
The control output ON/OFF times counting function can predict the fault of the internal relay of the temperature controller.