Size: M8(Stainless steel)(See note 2.); Double; Shielded.
Sensing distance: 2 mm.
Connecting method (See note 1.): Pre-wired.
Body length: Short.
Output configuration: NPN.
Operation mode NC.
A new generation in global applications. Sensing method: Reflective type.
Sensing distance: 0 to 3 mm EE-SX975P-C1 INSTRUCTION sheet.
Output configuration: Turns ON when wafer carrier is present.
Cable length: 2 m EE-SX975P-C1
Photomicrosensors for detecting,
wafer-carrier mounting.
The mounting position is set with a pedestal.
The contact surface with the wafer carrier uses a special chemical,
resistant fluororesin.
The unique optical system enables stable detection of almost all,
wafer-carriers.
Light modulation effectively reduces external light interference EE-SX975P-C1 INSTRUCTION sheet.
Utilizes talc-free clean cables. Size: 48 * 48mm, terminal type.
Category: control output 1 point type (power supply AC100 ~ 240V).
Shell color: black.
Control output: linear voltage output.
Control mode: standard or heating cooling.
Auxiliary output points: 2 points.
Heater break, SSR fault detection function: -.
Event entry point: 2.
Transfer output: output (special terminal) EE-SX975P-C1 INSTRUCTION sheet.
Communication: -.
New program type.
A new type of liquid crystal with high performance cost ratio is adopted in the 256 paragraph,
Visual angle, contrast can be improved.
Can be set up to 8 procedures (mode) x 32 (step) procedure.
High resolution 5 bit display / can display 0.01 degrees C (to achieve a small size of 48 x 48mm).
High speed sampling period 60ms.
Full of all models (capable of thermocouple /Pt/ analog input switching),
1 machines to support a variety of sensors.
Add PV/SV state display function, to see the state of tthe thermostat
(automatic / manual, RUN/RESET, alarm),
Interactive display PV/SV EE-SX975P-C1 Manual.
By supporting software (Ver.4.3 CX-Thermo),
In simple arithmetic functions (AND/OR logic and delay).
Setting the program settings that can performm flexible contact output EE-SX975P-C1 Manual.
The control output ON/OFF times counting function can predict the fault of the internal relay of the temperature controller.