Name: Bit Slave Units with e-CON Connectors.
Specifications: Outputs; 2 outputs; NPN.
Simple and Intelligent Bit Slaves,
with Industry-standard e-CON connectors.
Slave Units capable of 2-point bit-level distribution.
The I/O power supply is supplied from the communications,
power in the previously connected flat cable, and has a,
short-circuit detection function for protection CP1E-N30DT-A OPERATION MANUAL CP1E-N30DT-A
Industry-standard e-CON connectors.
Short-circuit protection safeguards the network,
from I/O short circuits.
Simple communications connections,
with flat cable and connectors.
Bit-level distribution to support,
essentially any application. Model: C200H-DA002.
Input points: 4.
Voltage input: –10 to 10V CP1E-N30DT-A OPERATION MANUAL.
Current input: 4 to 20 mA.ASCII Unit
This program runs independently from the ladder-diagram program in the PLC.

Name: ASCII Module.
Model: C200H-ASC21.
Communications port>Port 1: RS-232C(peripheral device or termi-nal connection).
Communications port>Port 2: RS-422A/485(peripheral Unit type: CS1 Special I/O Units.
Product name: Isolated-type Resistance,
Thermometer Input Units (Ni508.4 Ω) CP1E-N30DT-A OPERATION MANUAL.
points Input: 4 inputs.
Signal range selection:
Set separately for each input.
I/O type: INi508.4.
Conversion speed (resolution):
100 ms/4 inputs.
Externa connection: Removable erminal block.
No. of unit numbers allocated: 1.
Current consumption: 5V, 0.15A; 26V, 0.15A.
Standards: UC1, CE.
Provides the functionality of isolators,
power supplies, signal converters,
and other devices.
The Analog Input Unit converts analog,
input signals such as 1 to 5 V or 4 to 20mA,
into digital values, and takes the values,
scaled in industrial units, and transfers,
it to the CPU Unit as the process value.
Because of this, no ladder program is required,
at the CPU Unit for scaling.
The Analog Output Unit converts analog output set,
values from the CPU Unit to analog output signals,
such as 4 to 20 mA or 1 to 5 V, and outputs them.
The built-in functions, such as measurement value,
alarms, rate-of-change calculations, and square roots,
have enabled major savings in cost and space compareed,
with previous systems CP1E-N30DT-A Software Manual.
High-resolution Models and 8-point Input Models are,
also available.
By combining the Units, logging/monitoring.
systems can be constructed,
or the Units can be used together with LCBs/LCCUs,
to construct complete process control systems CP1E-N30DT-A Software Manual.
Parameters can be easily displayed and set in an,
easy-to-understand form without special tools.