Model: C200HW-ME32K.
Capacity: 32K words.Model: C200H-TS001.
Temperature sensor: Thermocou-ples: K(CA), J(IC)(selectable).
Input points: 4 points/Unit max. (1, 2, or 4 points can be selected).Power supply: DC power supply.
Output method: Transistor output sink type.
Inputs points: 6 points.
Outputs points: 4 points CP1E-N40DT-D Operation Manual. Name: MIL Connectors.
Specifications: Inputs;
32 inputs ; NPN; -- CP1E-N40DT-D
"Easy" and "Flexible" system expansion,
with linked CC-Link and CompoNet.
Branching is easily made with CompoNet.
Wiring material cost can be reduced.
Bit-level I/O distribution reduces,
wiring in the system.
A wide variety of CompoNet Slave Units,
contribute to system size reduction.
Seven-segment Display on the Gateway Unit,
helps to detect errors on site CP1E-N40DT-D Operation Manual.
The Participation Flags and Communications,
Error Flags can be checked at the Host,
Controller to detect the location and,
content of the error. C500-RT SYSMAC BUS Remote I/O Master Slave Wired C500-RT002-PV1.
APF/PCF.With two optical connectorsModel: CPM2C-20EDR. Units with 20 I/O points.
1 I/O terminal block.
Inputs: 12 inputs.
Outputs: 8 outputs CP1E-N40DT-D Operation Manual.
Input type: 24 VDC.
Output type: relay.Unit classifi cation: CS1 CPU Bus Unit.
Product name:Controller Link Unit.
Specifications: Communications cable,
Optical ring H-PCF cable;
Communications type, Data links and,
message service; Duplex support,
Yes. Unit duplexing and cable loop,
back are supported.
Max. Units mountable per CPU Unit,
Non-duplex: 8, Duplex: 11 (6 Units,
comprising 3 sets of Duplex Units,
+ 5 Non-duplex Units).
No. of unit numbers allocated: 1.
Current consumption: 5V, 0.52A; 26V, --.
Standards: UC1, N, L, CE.
New Controller Link Units,
Now with 4,000 Send Words.
The Controller Link is an,
FA network that can send,
and receive large amounts,
of data easily and at high speeed CP1E-N40DT-D Manual.
The Controller Link supports data,
links that enable sharing data between,
PLCs and computers and a message service,
that enables sending and receiving,
data whenever required.
With Wired Controller Link Units,
systeems can be flexibly built by using,
Repeater Units to enable T branches,
long-distance wiring, and converting,
part of the network to optical cable CP1E-N40DT-D Manual.