NO. OF I/O SLOTS: 10 SLOTS80 cm for CP1W/CPM1A Expansion UnitsPower supply voltage: DC100V.
Note: operation with output contacts.
Power supply unit.
The power supply of the CPU rack is supplied by the power supply unit.
The following power units are available for selection.
C200HW-PA204 (voltage: AC100-120V/AC200-240V)
C200HW-PA204S (voltage: AC100-120V/AC200-240V)
C200HW-PA204R (voltage: AC100-120V/AC200-240V)
C200HW-PD024 (voltage: DC24V)
In the past, PC connected to a measurement equipment or components must be given to the ASCII unit or BASIC unit to write a communication program CPM1A-40CDT1-A-V1 OPERATION MANUAL CPM1A-40CDT1-A-V1
Now, PC C200HX/HG/HE is installed on the communication protocol macro function,
Can be configured to these communications procedures through the PMCR instruction to the ladder program,
With this function system can be easily connected with a wide range of components CPM1A-40CDT1-A-V1 OPERATION MANUAL. CV500-RM SYSMAC BUS Remote I/O Master Unit Wired CV500-RM221.
Wire Type.Output method: Analog resolution: 1/6000.
Analog Outputs: 4.Model: C200H-ME832.
Description: EEPROM, 8K words, battery back-up.with clock(CPU21, CPU23 only).CPU Unit: CP1H-X CPU Units CPM1A-40CDT1-A-V1 OPERATION MANUAL.
Specifications: CPU type, Memory capacity: 20K steps
High-speed counters: 100 kHz, 4 axes Pulse outputs:
100 kHz, 2 axes (Models with transistor outputs only);
Power supply, AC power supply; Output method, Relay output;
Inputs, 24; Output, 16.
Standards: UC1, N, L, CE.
4 Axis Position Control and Comprehensive Programmable Controller.
The CP1H-X with pulse outputs for 4 axes.
The CP1H-Y with 1-MHz pulse I/O.
The CP1H-XA with pulse outputs for 4 axes and built-in analog I/O. Model : CVM1-DRM21-V1.
CVM1/CV series for.Model: C200H-BC031-V2.
No. of I/O slots: 3 slots.Power supply: DC power supply.
Output method: Transistor output source type.
Inputs points: 18 points.
Outputs points: 12 points.Model : CV2000-CPU01-V1.
SFC / Ladder 2, 048 (with RAM62K words, the top internal link).C500-GP Special I/O Unit GPIB Interface Unit C500-GPI01.For 3-slot Backplane.Name: Three-tier Screw Terminal Block.
Specifications: Outputs; 8 outputs; PNP;
With Short-circuit and,
Disconnected Line Detection.
"Easy" and "Flexible" system expansion,
with linked CC-Link and CompoNet.
Branching is easily made with CompoNet.
Wiring material cost can be rreduced CPM1A-40CDT1-A-V1 Manual.
Bit-level I/O distribution reduces,
wiring in the system.
A wide variety of CompoNet Slave Units,
contribute to system size reduction.
Seven-segment Display on the Gateway Unit,
helps to detect errors on sitee CPM1A-40CDT1-A-V1 Manual.
The Participation Flags and Communications,
Error Flags can be checked at the Host,
Controller to detect the location and,
content of the error.