Model: C1000H-TER01.
Each node requires one of the ends of the network.Feeding unit while the SYSMAC LINK Unit 2
If you need to.Power supply voltage: 100 to 240VAC.
Output capacity: 5-VDC output capacity, 2.8A;
24-VDC output capacity, 0.4A;
Total power consumption, 14w.
Options: 24-VDC service power supply, No;
RUN output, No; Maintenance forecast monitor, No CRT1-MD16 REFERENCE MANUAL.
Standards: UC1, N, L, CE CRT1-MD16
Equipped with the RUN output for,
checking the operation status,
as well as the replacement.
notification function for easy,
maintenance.
Lineup of five models including the,
AC power supply (25W).
Stable power supply is available from the,
CJ-series CPU Unit to each I/O Units via the,
dedicated bus CRT1-MD16 REFERENCE MANUAL. The most suitable Power Supply,
Unit can be selected among various I/O ,
specifications and/or options. Name: e-CON Connectors.
Specifications: Outputs; 32 outputs; NPN;
With Short-circuit and,
Disconnected Line Detection.
"Easy" and "Flexible" system expansion,
with linked CC-Link and CompoNet.
Branching is easily made with CompoNet.
Wiring material cost can be reduced.
Bit-level I/O distribution reduces,
wiring in the system CRT1-MD16 REFERENCE MANUAL.
A wide variety of CompoNet Slave Units,
contribute to system size reduction.
Seven-segment Display on the Gateway Unit,
helps to detect errors on site.
The Participation Flags and Communications,
Error Flags can be checked at the Host,
Controller to detect the location and,
content of the error. I/O points: 256 pts.
Program capacity(words): 7.2 K.
DM capacity (words): 6 K.
RS-232C port: YES.
ABS interface: Yes.Number of outputs: 8 pts.
Input Voltage: 250 VAC, 24 VAC.
Max Switching Current: 2 Amps.
Common Type: Independent.Power supply: DC power supply.
Output method: Transistor output sink type.
Inputs points: 6 points.
Outputs points: 4 points.Model: C500F-CPUA1-E(3G2C3-CPUA1-E).
C500F-CP CPU Programmable Controller C500F-CPUA1-E.Unit type: CJ1 CPU Bus Units.
Product Name: Position Control,
Unit with MECHATROLINK-II interface.
Specifications: Control commands,
executed by MECHATROLINK-II,
synchronous communications.
Direct operation by ladder programming.
Control mode: Position control,
speed control or torque control;
No. of axes: 4 axes.
No. of unit numbbers allocated: 1 CRT1-MD16 Manual.
Current consumption : 5V, 0.36A; 24V,--.
Standards: UC1, CE.
Decrease TCO with Simple Operation,
Reduced Wiring, Batch Settings,
and Batch Management.
Control Servos for up to 16 axes in,
a motion network with one Position,
Control Unit that supports MECHATROLINK-II CRT1-MD16 Manual.
MECHATROLINK-II is a registered trademark,
of the MECHATROLINK Members Association.