E32-L24S type: special light beam type; limited reflection,
Specialty: ultra small head,
Bending radius (mm): R10.
Standard test object (minimum test object) (mm) 1: (0.005),
Fiber element for meeting diversified needsItem: Standard models.
Functions: Timer, Response speed change.
Model: NPN output E2E-X18MY1-M1J-Z INSTRUCTION sheet.
Advanced Fiber Amplifier Units.
Features a Power Tuning function that optimizes light,
reception at the press of a button E2E-X18MY1-M1J-Z
APC circuits to suppress LED aging degradation used with,
4-element LEDs.
2-channel models achieve the thinnest* profile in the industry,
at only 5 mm per channel.
2-channel models also offer AND/OR control output.
The E3X-MDA0 with two channels supports an EtherCAT Sensor E2E-X18MY1-M1J-Z INSTRUCTION sheet.
Communications Unit or CompoNet Sensor Communications Unit. Sensor type: Coaxial Retro-reflective with MSR function.
Sensing distance: 0 to 500 mm with E39-R1S.
Connection method: pre-wired.
Model: NPN output.
A new generation in sensing performance.
Simplicity.
Simple selection.
Simple installation.
One family for all.
All standard applications covered.
A wide variety of models E2E-X18MY1-M1J-Z INSTRUCTION sheet.
Models designed for special applications.
Non-stop detection.
High quality and reliability.
High EMC protection.
High light immunity.
Robust and waterproof housing. Detect Humidity within an Accuracy of ±3%,
in a Compact Body. Controller Set Provides,
Superior Humidity Control and Temperature/
Humidity Control.
Employs high-polymer-resistive Sensor with superior durability.
Compact and lightweight.
Measurement ranges of 20% to 95% for humidity and 0 to 55°C,
for temperature. Appearance: Shielded, M18.
Stable sensing area: 5 (10) mm.
Separate Amplifier Sensor with.
Sensitivity Adjustment.
Compact design with smaller Sensor Head.
Heat-resistance model available for application between.
-10 and 200°C. Size: 48 * 48mm, terminal type.
Category: control output 1 point type (power supply AC100 ~ 240V).
Shell color: black.
Control output: current output.
Control mode: standard or heating cooling.
Auxiliary output points: 2 points.
Heater break, SSR fault detection function: -.
Event input points: -.
Transfer output: output (using control output).
Communication: RS-232C.
New program type.
A new type of liquid crystal with high performance cost ratio is adopted in the 256 paragraph,
Visual angle, contrast can be improved.
Can be set up to 8 procedures (mode) x 32 (step) procedure.
High resolution 5 bit display / can display 0.01 degrees C (to achieve a small size of 48 x 48mm).
High speed sampling period 60ms.
Full of all models (capable of thermocouple /Pt/ analog input switching),
1 machines to support a variety of sensors.
Add PV/SV state display function, to see the state of the tthermostat
(automatic / manual, RUN/RESET, alarm),
Interactive display PV/SV E2E-X18MY1-M1J-Z Manual.
By supporting software (Ver.4.3 CX-Thermo),
In simple arithmetic functions (AND/OR logic and delay).
Setting the program settings that can performm flexible contact output E2E-X18MY1-M1J-Z Manual.
The control output ON/OFF times counting function can predict the fault of the internal relay of the temperature controller.