Name: Terminal Unit(Includes bus system without backplane.).
No. of control points: 24.
Functions: Equipped with communications terminals for power supply,
communications, and setting devices.
New DIN Track Mounting Temperature.
Controller.
Two channels of temperature control available despite width of,
only 22 E2EC-C2R5B1 INSTRUCTION sheet. 5 mm.
The Temperature Controller itself can be replaced without,
changing terminal wiring E2EC-C2R5B1
Use in combination with a compact Setting Display Unit to,
reduce communications programming requirements.
Front-panel LED indicators for easy operation monitoring.
Power supply and communications wiring not required between,
Units when mounted side-by-side.
CompoWay/F communications protocol supported E2EC-C2R5B1 INSTRUCTION sheet.
UL, CSA, and CE Marking compliance. The main body: terminal type, temperature input type.
Category: control output 1 point type (power supply AC100 ~ 240V).
Shell color: black.
Control output: relay output.
Control mode: standard or heating cooling.
Auxiliary output points: 2 points.
Heater with broken wire, SSR fault, heater over current detection function /ES1B power supply: single phase heater with detection function /ES1B power supply E2EC-C2R5B1 INSTRUCTION sheet.
Event input points: -.
Transfer output: -.
Communication: -.
48mm general thermostat has been upgraded & function / performance upgrade.
Indicates that the accuracy is increased and the preventive maintenance function is increased,
Further performance improvement.
E5CN-U (insert type) add analog input and current output type.
Add PV/SV status display function, convenient to check the state of the thermostat (automatic / manual, RUN/STOP, alarm),
Interactive display PV/SV.
Increase the number of controll output ON/OFF counting function, can prevent the maintenance of temperature controller internal relay E2EC-C2R5B1 Manual. 1M E32-T54V type: environmental type; vacuum resistance,
Specialty: L word shape heat: 200,
Shape / detection distance (mm):: 500; 660; 330 (180),
Bending radius (mm): R30 E2EC-C2R5B1 Manual.
Standard test object (minimum test object) (mm) 1: 4 (0.1),
Fiber element for meeting diversified needs