Name: Repeater Unit.
Specifications: A sub-trunk line can be,
connected downstream,
(for trunk-branch line configuration),
or further branching is enabled downstream,
(for configurations with no wiring restrictions),
in the same way as for a Master Unit.
A Repeater Unit can be used to branch,
the trunk line and increase the,
number of connected Units,
as well as to extend the length of the,
communications line CJ1W-TC102 PROGRAMMING MANUAL CJ1W-TC102
Standards: CE, U, U1, L, N.
Simple and Intelligent Bit Slaves,
with Industry-standard e-CON connectors.
Slave Units capable of 2-point bit-level distribution.
The I/O power supply is supplied from the communications,
power in the previously connected flat cable, and has a,
short-circuit detection function for protection CJ1W-TC102 PROGRAMMING MANUAL.
Industry-standard e-CON connectors.
Short-circuit protection safeguards the network,
from I/O short circuits.
Simple communications connections,
with flat cable and connectors.
Bit-level distribution to support,
essentially any application. C500-ID Special I/O Unit ID Sensor Unit General Purpose C500-IDS01-V2Name: e-CON Connectors.
Specifications: Outputs; 16 outputs; PNP;
With Short-circuit and,
Disconnected Line Detection CJ1W-TC102 PROGRAMMING MANUAL.
"Easy" and "Flexible" system expansion,
with linked CC-Link and CompoNet.
Branching is easily made with CompoNet.
Wiring material cost can be reduced.
Bit-level I/O distribution reduces,
wiring in the system.
A wide variety of CompoNet Slave Units,
contribute to system size reduction.
Seven-segment Display on the Gateway Unit,
helps to detect errors on site.
The Participation Flags and Communications,
Error Flags can be checked at the Host,
Controller to detect the locatiion and,
content of the error CJ1W-TC102 Manual. I/O Control UnitName: External Connector.
Model: C500-CE403.
Specifications: Pressure welded terminal; 40p.Output method: Transistor sinking.
Inputs: ---.
Outputs: 8.Model : CV500-CIF01.
Port forr peripherals (6m) 25-pin CJ1W-TC102 Manual. Power supply: AC power supply.
Output method: Transistor output sink type.
Inputs points: 12 points.
Outputs points: 8 points.