Input type: high speed response type.
Event input terminal 5 points (TIMING, S-TIM, HOLD, RESET, ZERO) is equipped with.
External power supply DC12V80mA.
Output type: DeviceNet; -; DeviceNet.
96 (W) * 48 (H * 95mm) depth.
Power supply voltage: AC100 ~ 240V.
High speed, high precision measurement, determine the color display,
Can switch the green / Red 2 kinds of display colors.
Equipped with the sub pressure gauge for monitoring the operation trend F39-HN0423-14
External event input can be applied to a variety of measurement and identification situations.
Series of DeviceNet type.
The depth (panel below) is only short size 95mm.
UL standard for recognitionType: square.
Screen mode: no segmentation.
Using voltage: DC12V.
Operation Department color: Blue (using yellow and green LED).
Micro design, the length of the body is only 23mm.
LED has five colors (red, yellow, green, white, and blue).
Chip LED to produce a uniform surface brightness.
From the front panel installation, more convenient. Unit type: CJ1 CPU Bus Units.
Product Name: Position Control,
Unit with MECHATROLINK-II interface.
Specifications: Control commands,
executed by MECHATROLINK-II,
synchronous communications.
Direct operation by ladder programming.
Control mode: Position control,
speed control or torque control;
No. of axes: 16 axes.
No. of unit numbers allocated: 1.
Current consumption : 5V, 0.36A; 24V,--.
Standards: UC1, CE.
Decrease TCO with Simple Operation,
Reduced Wiring, Batch Settings,
and Batch Management.
Control Servos for up to 16 axes in,
a motion network with one Position,
Control Unit that supports MECHATROLINK-II.
MECHATROLINK-II is a registered trademark,
of the MECHATROLINK Members Association. Rugged Rotary Encoder.
Incremental model.
External diameter of 60 mm.
Resolution of up to 1000 ppr.
IP65 oil-resistance with strong shaft.
Radial: 120 N, Thrust: 50 N. Unit name: Loop Control Boards.
Specifications: No. of function blocks:
500 blocks max.
Standards: UC1, N, CE.
The open nature of the PLCs is joined,
by integrating hardware, software,
and networking to meet your needs.
Increasing amounts of information,
standardization, and open standards,
form the basis for achieving hardware,
and networking capabilities for process control.
A wide range of software that can be easily,
used by design, development, and maintenance,
personnel makes operating and maintaining,
the system far easier.
F39-HN0423-14 Operation manual/Instructions/Model selection sample download link: /searchDownload.html?Search=F39-HN0423-14&select=5