Insulation method: Phototriac.
Operation indicator: Yes.
Zero cross function: NO.
Applicable load: 2 A at 100 to 240 VAC.
Input rated voltage: 5 to 24 VDC.
SSR with Plug-in Terminals.
The Same Shape as the G2R-1-S.
Power Relays.
These I/O solid state relays can be mounted in OMRON.
G70A I/O Terminals.
Modules for standard loads.
(-UTU models).
Insulation mode: three end two-way switch coupler.
Zero trigger function: No.
Action indicator: there.
Applicable load of output: AC5 240V ~ DC5 1.0A ~ 100V.
Input rated voltage: DC5V.
With the same shape of the power FET MOS G2R relay AC/DC dual, can achieve 1A load switching performance.
Can achieve AC240V or DC100V, 1A load switch OMRON G3R-OA202SLN DC5-24.
Output open circuit leakage current: 10 A
G3R-OA202SLN DC5-24
Input / output voltage resistance AC2500V.
Built in input resistance and over voltage absorbing circuit.
Can be carried out AC full wave rectifier load, half wave rectifier load switch.
Type: Conforming to auxiliary power relay specifications.
Contact form: DPDT+DPST-NO.
Cased: Plug-in (octal pins) terminals OMRON G3R-OA202SLN DC5-24.
Mechanically Latching Relays Based on the.
MM Power Relay.
Low power consumption due to mechanical latch for economic operation.
Relays with mixed coil specifications can be produced,
(e.g., AC setcoil and DC reset coil).
Operational response fast enough to enable pulse signal power applications.
Ambient operating temperature: –10°C to 55°C. Optimum Cycle Control for High-precision.
Control with Low Noise OMRON G3R-OA202SLN DC5-24.
Smaller than a Normal Power Controller.
Enables low-noise power control in combination with zero-cross.
SSRs. (See note.).
One Controller can control up to 8 SSRs.
RS-485 communications to set manipulated variables and,
heater burnout detection. The Smart FB Library for the G3ZA,
can also be used.
CE Marking.
Main Upgraded Functions.
Soft-start function added for lamp heaters.
Three-phase optimum cycle control added for three-phase heaters.
Combining with special CT for150-A current detection.
Note: The G3ZA must be used in combination with an SSR without the,
zero cross function when the soft-start function is used. Type: input module.
Insulation: photo coupler.
Action display lamp.
Logic suupply voltage: DC4 ~ 32V G3R-OA202SLN DC5-24.
Logic supply current: 25mA.
Input rated voltage: AC100 ~ 240V.
Logic circuit and load interface.
I/O solid state relay.
With the input module (AC, DC), the output module (AC, DC).
Product series, tthe color of each module to distinguish G3R-OA202SLN DC5-24.
You can confirm the action of SSR by using the action display light.
Between input and output voltage 4000V.