LK Automation Limited LK Automation Limited
Brand: OMRON
Go Back >> Product Catalogues
XW2Z-500H-1 | OMRON Connecting Cables for Connector-Terminal Block Conversion Units XW2Z-500H-1
OMRON XW2Z-500H-1 Manual And Instructions
XW2Z-500H-1 datasheetPDF datasheet

OMRON XW2Z-500H-1 Product information and technical parameters:
Brand: OMRON
Name: Connecting Cables for Connector-Terminal Block Conversion Units
Model: XW2Z-500H-1
Cable length L: 5.0 m.
Connect Connector-Terminal,
Block Conversion Units (XW2@) to,
I/O Units for Programmable,
Controllers with one touch.

Model: PL (back-mounting), page 26, Solder terminals.
Approx: 28 g.
Number of pins: 14 pins.
A Wide Variety of Square and,
Round Sockets in Front-mounting,
and Back-mounting Models,
Models available with finger protection.
Hold-down Clips and Socket Bridges for PYF Sockets,
are also available OMRON XW2Z-500H-1.
New screwless models available. Time specification: Instantaneous type.
Current setting range: 20 to 65 A XW2Z-500H-1
Operating voltage: 400/440 VAC.
Resetting method: Manual.
Solid-state Relay Enables Choice of Three.
Operating Functions (Overcurrent, Open,
phase, and Reverse-phase).
Protects 3-phase induction motors and their loads from damage.
Selection and combination of operating functions from overcur,
rent, open-phase, and reverse-phase OMRON XW2Z-500H-1.
Circuit and output relay operation can be checked by just operat,
ing the test button.
The set time value can be checked easily because operation time,
is indicated from the start of operation.
Space-saving, integrated construction.
Note: If the K2CM is used with an inverter, the operating conditions will,
depend on the load wiring length, inverter carrier frequency, basic,
frequency, and load conditions OMRON XW2Z-500H-1. Error will occur in the operating,
values of the overload elements. It is recommended to test operation,
before using the K2CM. Control power supply voltage: 48 VDC.
Input: DC or AC (selectable), Input voltage range, 10 to 300 V.
Overvoltage/Undervoltage Monitoring.
Relay for AC and DC Input.
Detect overvoltages or undervoltages (switch select,
able) from 4 mV to 300 V.
Detect undercurrent, reverse current, or overcurrent in,
DC circuits using shunt (SDV-FL).
Detect three-phase AC current for under and/or overcur,
rent using current converterr XW2Z-500H-1.
Available in 7 supply voltage configurations.
Single-function model with ON-delay, OFF-delay, or star,
tup lock settings (SDV-FH@T).
Select either AC or DC voltage input.
Polarity can be specified (SDV-FL) to enable easy re,
verrse current detection XW2Z-500H-1.
Selectable reset value range from 2% to 30% of operat,
ing value (SDV-F).
LED operation indicator.
UL/CSA approval (SDV-F@).


...More relevant models >>>>
Last one: OMRON XW2Z-300H-1
next one: OMRON XW2Z-700H-1